The Linear GD00Z-5 is a Zwave enabled garage door sensor and opener for use with Zwave automation control systems.  The tilt sensor is installed on your garage door, allowing the system to know and report the open/close status to your automation system.

The GD00Z-5 connects to the garage door opener via 2 wires, to open and close the door when requested  by your automation system.  In order to meet industry standard safety requirements, the unit will provide a visual and audio warning before closing the door.

Linear GD00Z-5 Garage Door Opener and Status Kit Features:

• New model, replaces GD00Z-4 (mainly a packaging change)
• Includes garage door controller and wireless tilt sensor
• Works with Zwave certified automation controllers
• Main unit connects to garage door opener with two wires and pairs to your Zwave system
• Wireless tilt sensor attaches to garage door to report open/close status
• Visual and audio warning prior to closing door via Zwave command
• Controller dimensions: 6.94 x 1.38 x 5 inches
• Tilt sensor dimensions: 1.69 x 0.88 x 1.19 inches

Kit includes: 
controller, tilt sensor, plug-in power supply, mounting brackets and hardware 

Note: 
The GD00Z opens and closes your garage door by simulating  button press of the garage door button inside your garage.  You can test compatibility with your garage door opener by using a short piece of wire to momentarily bridge the two garage door button terminals.  If this opens, stops, and closes your garage door, then this kit is compatible.  If this doesn't work, it may be possible to add a Skylink or similar compatible rolling code remote.  This is a bit of a hack and voids the button warranty, but open up the remote and connect the GD00Z output to the button contacts.